the hour hammer spring is broken
the wheel in the middle is from an ETA, and was put in here to make the crown wheel ride up ....
this washer that was on top of the ratchet wheel doesn't belong here ...
winding pinion and sliding pinion worn
winding stem bush in plate worn
the calibre 285 hammer spring is a mirror image of the 281 hammer spring ...
drilling out the pin
making a new pin in the lathe
new pin
fitting the new pin
fits nicely now!
making a small sink for the screw
now the screw sits flush, and the month disc can turn freely
the month corrector has to go in further
the minute recorder hand is a bit too loose, even though someone tried to squeeze its tube before
tightening the minute recorder hand tube
the screw that was fitted for the hour recorder clutch
this is what the hour recorder clutch screw should look like!
extra washer on ratchet wheel that doesn't belong here
worn winding pinion and sliding pinion